NEC SL1000 - Dial Analysis Extension Table

Program 44 : ARS/F-Route Setup
44-03 : Dial Analysis Extension Table
Level
IN
Description
When Program 44-02-02 is set to type 3, use Program 44-03 : Dial Analysis Extension Table to set
the dial extension analysis table. These tables are used when the analyzed digits must be more than
eight digits. If the received digits do not match the digits set in tables 1 ~ 250, table number 252 is
used to refer to the next Extension Table Area (1 ~ 4) to be searched. If the received digits are not
identified in tables 1 ~ 250, the F-Route selection table number defined in table 251 is used.
Input Data
Extension Table Area Number 1 ~ 4
Dial Analysis Table Number 1 ~ 252
Dial Analysis Table Number:1~250
Item No. Item Input Data Default
01 Dial Up to 36 digits
Digits=1~9,0,
*
,#,@
(Press Line Key 1 for wild character @)
No setting
02 ARS/F-Route Select Table
Number
0 ~ 100 (ARS/F-Route Table Number)
With Program 44-01 set to 0, Program 44-05 is checked.
With Program 44-01 set to 1, Program 44-04 is checked.
0
Dial Analysis Table Number : 251
Item No. Item Input Data Default
03 ARS/F-Route Select Table
Number
0 ~ 100 (ARS/F-Route Table Number)
With Program 44-01 set to 0, Program 44-05 is checked.
With Program 44-01 set to 1, Program 44-04 is checked.
0
Dial Analysis Table Number : 252
Item No. Item Input Data Default
04 Next Table Area Number 0~4 0
Conditions
None
Feature Cross Reference
• Automatic Route Selection (ARS/F-Route)
ISSUE 1.0SL1000/SL1100
Program
44
Program 44 : ARS/F-Route Setup2-366