NEC SL1000 - VRS;DISA One-Digit Code Attendant Setup

Program 25 : VRS/DISA Setup
25-06 : VRS/DISA One-Digit Code Attendant Setup
Level
IN
Description
Use Program 25-06 : VRS/DISA One-Digit Code Attendant Setup to set up single digit dialing
through the VRS. This gives VRS callers single key access to extensions, the company operator, De-
partment Calling Groups and Voice Mail. For each VRS message set to answer outside calls (refer to
Programs 25-04 and 25-05), you specify:
• The digit the VRS caller dials (0 ~ 9,
*
, #). Keep in mind that if you assign destinations to digits,
outside callers cannot dial system extensions.
• The destination reached (Maximum four digits (SL1000) Maximum eight digits (SL1100)) when the
caller dials the specified digit.
The destination can be an extension, a Department Calling pilot number or the Voice Mail master num-
ber. A one-digit code can be assigned for each Automated Attendant message.
Example:
Message Number = 01, Destination = 2, Next Message Number = 0, Dial = 399
In this example, when 2 is dialed by an outside caller, the system transfers the call to 399. This means
that extension 200~299 cannot receive calls from VRS/DISA users during/after VRS Message 01.
Input Data
Attendant Message Number 01 ~ 100
ReceivedDial 1~9,0,
*
,#
Item No. Item Input Data Default
01 Next Attendant Message Number
Defines the next attendant message
number or destination number for
each 1-digit access code in Auto-
mated Attendant service
0 ~ 100 (0 = No setting)
101 = Voice Mail answers
104 = Refer to
25-04 : VRS/DISA Transfer
Ring Group With No Answer/Busy on page
2-281
105 = Dial the other extension
106 =record VRS
0
02 Destination Number Up to four digits (SL1000)
Up to eight digits (SL1100)
Must be a valid extension number
that is programmed in command
11-02 or 11-04.
No setting
Conditions
• Outside caller may not be able to dial individual extensions or lines if the same first digit is defined
here.
Feature Cross Reference
• Direct Inward System Access (DISA)
• Voice Response System (VRS)
ISSUE 1.0 SL1000/SL1100
Program
25
Programming Manual 2-283