Program 21 : Outgoing Call Setup
21-01 : System Options for Outgoing Calls
Level
IN
Description
Use Program 21-01 : System Options for Outgoing Calls to set the system options for Outgoing
Call Service.
Input Data
Item No. Item Input Data Default Related Program
01 Seizure Trunk Line Mode
Select the trunk based off the
Trunk Route Priority (0) or based
off the trunk that has not been
used in the longest time (1).
0 = Priority Route
1 = Circular Route
0 14-05
14-06
02 Intercom Interdigit Time
When placing Intercom calls, ex-
tension users must dial each digit
in this time.
0 ~ 64800 seconds 10 seconds
03 Trunk Interdigit Time (External)
The system waits for this time to
expire before placing the call in a
talk state (Call Timer starts after
time expires, Voice Over and
Barge-In is not allowed until after
time expires).
0 ~ 64800 seconds 10 14-02-08
04 Dial Tone Detection Time
If dial tone detection is enabled,
the system waits this time for the
Telco to return dial tone. When the
time expires, the system assumes
dial tone is not present. To disable
this time (and have the system wait
continuously), enter 0.
0 ~ 64800 seconds 5 seconds 14-02-05
05 Disconnect Time when Dial Tone
not Detected
If 14-02-11 is enabled, the system
skips over a trunk if dial tone is not
detected. This option pertains to
calls placed using Speed Dial,
ARS, Last Number Redial or Save
Number dialed. It does not pertain
to line key or Direct Trunk Access
calls.
0 ~ 64800 seconds 0
06 Dial Pause at First Digit 0 ~ 64800 seconds 3
07 Toll Restriction Override Time
After dialing the Toll Restriction
Override codes, the system re-
moves Toll Restriction from the
extension for this time.
0 ~ 64800 seconds 10 seconds 20-08-06
21-07
08 Preset Dial Display Hold Time 0 ~ 64800 seconds 5
09 Ringdown Extension Timer
(Hotline Start)
A Ringdown extension automati-
cally calls its programmed destina-
tion after this time.
0 ~ 64800 seconds 5 seconds 20-08-09
21-11
ISSUE 1.0 SL1000/SL1100
Program
21
Programming Manual 2-217
To Next Page
Loading...
