Use this keypad digit ... When you want to ...
3 Enter characters : D-F, d-f, 3.
4 Enter characters : G-I, g-i, 4.
5 Enter characters : J-L, j-l, 5.
6 Enter characters : M-O, m-o, 6.
7 Enter characters : P-S, p-s, 7.
8 Enter characters : T-V, t-v, 8.
9 Enter characters : W-Z, w-z, 9.
0 Enter characters : 0!“#$%&’()ôõúåäæöüαεθВ
*
Enter characters :
*
+,-./:;<=>?πΣσΩ∞¢£
#
# = Accepts an entry (only required if two letters on the same key are needed - ex :
TOM). Pressing # again = Space. (In system programming mode, use the right arrow
Softkey instead to accept and/or add a space.)
Clear/Back Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
SECTION 7 USING SOFTKEYS FOR PROGRAMMING
(This Feature is available for IP Phone Only.) (SL1000)
Each Display telephone with Softkeys provides interactive Softkeys for intuitive feature access. The
options for these keys will automatically change depending on where you are in the system program-
ming. Simply press the Softkey located below the option you wish and the display will change accord-
ingly.
Pressing the Cursor key Up or Down will scroll between the menus.
SECTION 8 WHAT THE SOFTKEY DISPLAY PROMPTS MEAN
(This Feature is available for IP Phone Only.) (SL1000)
When using a display telephone in programming mode, various Softkey options are displayed. These
keys will allow you to easily select, scan, or move through the programs.
_
Program Mode
Base Service OP1 OP2
_
Program Mode
Hard Mtnance
ISSUE 1.0SL1000/SL1100
Introduction1-6
To Next Page
Loading...
