NEC SL1000 - Selectable Display Messages

Program 20 : System Option Setup
20-16 : Selectable Display Messages
Level
SA
Description
Use Program 20-16 : Selectable Display Messages to enter the Selectable Display Messages.
There are 20 alphanumeric messages, with up to 16 (SL1000) 48 (SL1100) characters. Use the follow-
ing chart when programming messages.
Use this keypad digit ... When you want to ...
1
Enter characters: 1@[¥]^_`{|}
ÁÀÂÃÅÆÇÉÊìó0
2 Enter characters : A-C, a-c, 2.
3 Enter characters : D-F, d-f, 3.
4 Enter characters : G-I, g-i, 4.
5 Enter characters : J-L, j-l, 5.
6 Enter characters : M-O, m-o, 6.
7 Enter characters : P-S, p-s, 7.
8 Enter characters : T-V, t-v, 8.
9 Enter characters : W-Z, w-z, 9.
0 Enter characters : 0!“#$%&’()ôõúåäæöüαεθВ
*
Enter characters :
*
+,-./:;<=>?πΣσΩ∞¢£
# # = Accepts an entry (only required if two letters on the same key are needed - ex :
TOM). Pressing # again = Space. (In system programming mode, use the right arrow
soft key instead to accept and/or add a space.)
Clear/Back Clear the character entry one character at a time.
Flash Clear all the entries from the point of the flashing cursor and to the right.
Input Data
Selectable Display Message Number 01 ~ 20
Item No. Input Data
01 16 characters (SL1000)
48 characters (SL1100)
Default
Number Message
1 IN MEETING UNTIL ## : ##
2 MEETING ROOM - ########
3 COME BACK ## : ##
4 PLEASE CALL ###########
5 BUSY CALL AFTER ## : ##
6 OUT FOR LUNCH BACK ## : ##
ISSUE 1.0SL1000/SL1100
Program
20
Program 20 : System Option Setup2-184