NEC SL1000 - Trunk Ring Tone Range; Table 2-5 Program 22-03 - Incoming Signal Frequency Patterns (SL1000); Table 2-6 Program 22-03 - Incoming Signal Frequency Patterns (SL1100)

Program 22 : Incoming Call Setup
22-03 : Trunk Ring Tone Range
Level
IN
Description
Use Program 22-03 : Trunk Ring Tone Range to select the ring tone range for the trunk. The trunk
uses a ring tone in the range selected when it rings an extension. Eight ring tones are available. Cus-
tomize the Trunk Ring Tones in Program 82-01.
Input Data
Trunk Port Number 001 ~ 126 (SL1000)
001 ~ 096 (SL1100)
Item No. Ring Tone Pattern Default Description Related Program
01 0= Ring Tone Pattern 1 (1) (SL1000)
1= Ring Tone Pattern 2 (2) (SL1000)
2= Ring Tone Pattern 3 (3) (SL1000)
3= Ring Tone Pattern 4 (1) (SL1000)
4= Ring Tone Pattern 5(2) (SL1000)
5= Ring Tone Pattern 6(3) (SL1000)
6= Ring Tone Pattern 7(3) (SL1000)
7= Not Used (SL1000)
8= Not Used (SL1000)
0= Ring Tone Pattern 1 (SL1100)
1= Ring Tone Pattern 2 (SL1100)
2= Ring Tone Pattern 3 (SL1100)
3= Ring Tone Pattern 4 (SL1100)
4= Melody 1 (SL1100)
5= Melody 2 (SL1100)
6= Melody 3 (SL1100)
7= Melody 4 (SL1100)
8= Melody 5 (SL1100)
0 Use this program to se-
lect the ring tone range
for the trunk. The trunk
usesaringtoneinthe
range selected when it
rings an extension. Eight
ring tones are available.
15-02
Table 2-5 Program 22-03 - Incoming Signal Frequency Patterns (SL1000)
Incoming Signal Frequency Pattern Tone Type
Pattern 1 600/450/16 Hz FM
Pattern 2 450/16 Hz AM
Pattern 3 600 Hz
Pattern 4 1100/1400/16 Hz FM
Pattern 5 660/760/16 Hz FM
Pattern 6 1100/1400/8 Hz FM
Pattern 7 660/760/8 Hz FM
Table 2-6 Program 22-03 - Incoming Signal Frequency Patterns (SL1100)
Incoming Signal
Frequency Pattern
Type Frequency 1 Frequency 2 Modulation
Pattern 1 High
Middle
Low
1100Hz
660Hz
520Hz
1400Hz
760Hz
660Hz
16Hz
16Hz
16Hz
Pattern 2 High
Middle
Low
1100Hz
660Hz
520Hz
1400Hz
760Hz
660Hz
8Hz
8Hz
8Hz
ISSUE 1.0SL1000/SL1100
Program
22
Program 22 : Incoming Call Setup2-246