Program 22 : Incoming Call Setup
22-02 : Incoming Call Trunk Setup
Level
IN
Description
Use Program 22-02 : Incoming Call Trunk Setup to assign the incoming trunk type for each trunk.
There is one item for each Night Service Mode.
Input Data
Trunk Port Number 001 ~ 126 (SL1000)
001 ~ 096 (SL1100)
Item
No.
Day/Night
Mode
Incoming Type Default Description
Related Pro-
gram
01 1 ~ 8 0 = Normal
1 = VRS (second dial tone if
no VRS installed)
2=DISA
3=DID
4=DIL
5 = E&M Tie line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID (DDI) Mode Switch-
ing
0 Use this option to set the feature type
for the trunk you are programming.
14-04
Conditions
• When connecting to T1 trunks, after changing Program 22-02-01 to match the Telco connected T1
service type, the T1 cable or the T1 unit must be unplugged and then reconnected for the T1 unit to
sync.
• When the trunk type is set to 3 (DID), the DID Transfer to Destination in 22-11-04 for each DID fea-
ture is not supported. This feature is supported only for DID trunks when assigned as VRS.
• When the trunk type is set to 3 (DID), the DID Intercept Destination feature for each DID is not sup-
ported. This feature is supported only for DID trunks assigned as VRS.
Feature Cross Reference
• Central Office Calls, Answering
ISSUE 1.0 SL1000/SL1100
Program
22
Programming Manual 2-245
To Next Page
Loading...
