NEC SL1000 - Trunk Access Code

Program 11 : System Numbering
11-09 : Trunk Access Code
Level
IN
Description
Use Program 11-09 : Trunk Access Code to assign the trunk access code. The trunk access code
canbesetfrom1~8digits which is defined to type 3 and 4 in Program 11-01. This is the code exten-
sion users dial to access Automatic Route Selection (ARS/F-Route). The Individual Trunk Access Code
is used when Trunk Group Routing is desired for an outgoing line.
Caution!
Thedigit9isdefinedinProgram11-01asDialType()withtheNumber of Digits Required set to ( ). If you change the
trunk access code in Program 11-09, you must make the corresponding changes in Program 11-01.
Input Data
Item No. Trunk Access Code Description Default Related Program
01 Dial (Up to four digits) Use this program to
assign the trunk ac-
cess code. This is the
code extension users
dial to access Auto-
matic Route Selection
(ARS/F-Route).
9 • 11-01 : System
Numbering
• 14-01 ~ 07 : Basic
Trunk Data Setup
• 14-05 : Trunk
Group
• 14-06 : Trunk
Group Routing
• 21-02 : Trunk
Group Routing for
Extensions
02 2nd Trunk Route Access
Code
Use this program to
define additional trunk
access codes.
When a user dials the
Alternate Trunk Route
Access Code, the sys-
tem routes their call to
the Alternate Trunk
Route.
No setting • 11-01 : System
Numbering
• 14-01 ~ 07: Basic
Trunk Data Setup
• 14-05 : Trunk
Group
• 14-06 : Trunk
Group Routing
• 21-02 : Trunk
Group Routing for
Extensions
• 21-15 : Individual
Trunk Group Rout-
ing for Extensions
Conditions
None
Feature Cross Reference
• Automatic Route Selection (ARS/F-Route)
• Central Office Calls, Placing
• Trunk Group Routing
ISSUE 1.0SL1000/SL1100
Program
11
Program 11 : System Numbering2-64