NEC SL1000 - Firmware Update Time Setting

Program 90 : Maintenance Program
90-36 : Firmware Update Time Setting
Level
IN
Description
Note: This program is available only via telephone programming and not through PC Programming.
Use Program 90-36 : Firmware Update Time Setting to define the data for the firmware update fea-
ture. This data is available to set from the PC Programming FW update feature.
The following firmware is available to update with this feature:
• main.bin
• Dspdbu.bin
• dsp.bin
• intradbu.bin is not supported
Input Data
Item No. Item Input Data Default Description
01
Firmware Update Sched-
ule Time
Year:0~99 0 Setthetimetoupdate the firmware
using a compact flash card.
Time registration fails if an expired
time is registered.
Month:0~12 0
Day:00~31 0
Hour:00~23 0
Minute:00~59 0
02 Update mode 0 = Non Active
1 = Activated
0 Activate the Firmware Update fea-
ture. If this setting is 1, new firmware
on the compact flash card updates
according to the setting at 90-36-01.
03 Update Report Maximum 256
characters
- Output a report when the update is
executed and saves one copy on the
system. If a new update occurs, the
new report overwrites the old report.
Refer to the
Sample Report on this
page shown.
Sample Report
Result Report Display
Update Success Update Success
Update Fail Update is fail. Since ‘A’ drive is not available.
Update Fail Update is fail. Since main up is not exist on A drive.
Update Fail Update is fail. Since Time is expired.
Conditions
None
Feature Cross Reference
None
ISSUE 1.0 SL1000/SL1100
Program
90
Programming Manual 2-551