NEC SL1000 - Page 141

Item
No.
Item Input Data Default
Related
Program
Note
04 Redial (Speed Dial) Control
Use this option to control the
function of the extension Redial
key when used with Speed Di-
aling. The Redial key can ac-
cess either the Common/
Individual or Group Speed
Dialing numbers.
0 = Common Abbreviated Dial
1 = Group Speed Dialing
2 = Directory Dialing (SL1000)
0
05 Transfer Key Operation Mode
Use this option to set the oper-
ating mode of the extension
Transfer key. The keys can be
for Call Transfer, Serial Calling
or Flash. When selecting the
Flash option (selection 2), refer
also to Program 81-01-14.
0 = Transfer
1 = Call back
2 = Hook
0
06 Hold Key Operating Mode
Use this option to set the func-
tion of the Multiline Hold key.
The Hold key can activate nor-
mal Hold or Exclusive Hold.
0 = Normal (Common)
1 = Exclusive Hold
2 = Park Hold
0
07 Automatic Hold for CO Lines
When talking on a CO call and
another CO line key is pressed,
the original trunk is placed on
Hold (0) or Disconnected (1).
0 = Hold
1 = Disconnect (Cut)
1
08 Automatic Handsfree
Use this option to set whether
pressing a key access a One-
Touch Key or if it preselects the
key.
0 = Preselect
1 = One-Touch (Automatic Handsfree)
1
10 Ringing Line Preference for
Trunk Calls
Use this option to select be-
tween Idle and Ringing Line
Preference for trunk calls.
0=Idle(Off)
1 = Ringing (On)
1
11 Callback Automatic Answer
Use this option to enable or
disable automatic answer of
calls recalling to a station. For
example, if a Transfer Recall or
Hold Recall is ringing back to a
station, the following happens:
If Program 15-02-11 is enabled,
the station will automatically
answer the recall when it goes
off-hook. If Program 15-02-11 is
disabled, a station does not
automatically answer the recall
when it goes off-hook. The user
must first press the line appear-
ance of the recalling call or
press the answer key.
0=Off
1=On
1
12 Off-Hook Ringing
Use this option to set the tele-
phone Off-hook signaling. Off-
hook signaling occurs when a
telephone user receives a sec-
ond call while busy on a hand-
set call. To enable/disable Off-
hook signaling for an extension
Class of Service, use Program
20-13-06.
0 = Muted Off-Hook Ringing
1 = No Off-Hook Ringing
3 = Beep in Speaker (SP)
4 = Beep in Handset (HS)
5 = Speaker and Handset Beep
0
13 Redial List Mode
Select whether the Redial List
feature should store internal
and external numbers (0), or
only external numbers (1).
0 = ICM/Trunk (Extension/Trunk
Mode)
1 = Trunk Mode
0
ISSUE 1.0 SL1000/SL1100
Program
15
Programming Manual 2-119