NEC SL1000 - Page 179

Item
No.
Item Input Data Default
Related
Program
Note
07 Time and Date Display
Mode
Set how the Time and
Date appear on display
telephones. There are
eight display modes.
1 ~ 10 (SL1000)
Type1=(12hour) TUE 103:15PM(SL1000)
Type2=(12hour) 3-10 TUE3:15(SL1000)
Type3=(12hour) 10-3 TUE3:15(SL1000)
Type4=(12hour) MAR 10 TUE3:15(SL1000)
Type5=(24hour) TUE 10 3 15 : 15 (SL1000)
Type6=(24hour) 3-10 TUE 15 : 15 (SL1000)
Type7=(24hour) 10-3 TUE 15 : 15 (SL1000)
Type8=(24hour) MAR 10 TUE 15 : 15
(SL1000)
Type9=(12hour) 10 MAR TUE3:15(SL1000)
Type 10 = (24 hour) 10 MAR TUE 15 : 15
(SL1000)
1~8(SL1100)
Type1=(12hour) 10 MAR TUE3:15PM
(SL1100)
Type2=(12hour)3:15PMMAR10TUE
(SL1100)
Type3=(12hour) 3-10 TUE3:15PM(SL1100)
Type4=(12hour)3:15PMTUE10MAR
(SL1100)
Type5=(24hour) 10 MAR TUE 15 : 15
(SL1100)
Type6=(24hour) 15 : 15 MAR 10 TUE
(SL1100)
Type7=(24hour) 3-10 TUE 15 : 15 (SL1100)
Type8=(24hour) 15 : 15 TUE 10 MAR
(SL1100)
1 (SL1000)
3 (SL1100)
08 LCD Display Holding
Time
0 ~ 64800 seconds 5
09 Disconnect Supervision
Use this option to enable
or disable disconnect su-
pervision for the system
trunks.
0=Disable(Off)
1 = Enable (On)
1
10 Time Before Shifting to
Power-Saving Mode
0=NoShift
1=1minute
2=2minutes
3=4minutes
4=8minutes
5=16minutes
6=32minutes
7=64minutes
0 15-02-18
11 Handsfree Microphone
Control
Use this option to control
the setting for Multiline
Terminal Handsfree micro-
phone after being discon-
nected and reconnected. If
set to 0, the microphone is
always off when the termi-
nal is reconnected. If set
to 1, the microphone re-
mains in the same state it
was in when the terminal
is reconnected.
0=Off
1=On
1
12 Forced Intercom Ring
(ICM Call Type)
Use this option to enable
or disable Forced Inter-
com Ringing. If enabled,
incoming Intercom calls
normally ring. If disabled,
Intercom calls voice-
announce.
0 = Disable (Voice)
1 = Enable (Signal)
1
15 Caller ID Display Mode 0 = Name and Number (Both)
1 = Name
2 = Number
0
ISSUE 1.0 SL1000/SL1100
Program
20
Programming Manual 2-157