NEC SL1000 - Page 278

Item No. Input Data Description Default
02 Target Number
Enter the destination number to
which the DID number is sent.
Maximum 36 digits
(0~9,
*
,#,@)
See Default Value
03 DID Name
This is the name that is assigned to
the DID digits when it rings the ex-
tension.
Maximum 12 characters No setting
04 Transfer Operation Mode 0 = No Transfer
1 = Busy
2 = No Answer
3 = Busy/No Answer
0
05 Transfer Destination Number 1 0=Noset
01 ~ 25 = Incoming Ring Group
102 = VMI
201 ~ 232 = Department Group
400 = DUD
401=DISA
501~599=DISA
(VRS Message No.)
1000 ~ 1999 =
Common ABB Dial (000 ~ 999)
0
06 Transfer Destination Number 2
400 - Allow the outside party to dial a
different extension number in the
translation table (for example, ring no
answer to a dialed number, the caller
then hears a dial tone, allowing them
to enter another Valid Extension
Number).
401 - Provide the caller with DISA
dialing options (requires using the
DISA password).
This applies to 22-11-05
and 22-11-06.
0
07 Call Waiting
Program 20-09-07 overrides this set-
ting.
0 = Disable (No)
1 = Enable (Yes)
0
08 Maximum Number of DID Calls 0 ~ 126 (0 = No limit) (SL1000)
0 ~ 096 (0 = No limit) (SL1100)
0
09 Music on Hold Source 0 = IC/MOH Port
1 = BGM Port
0
11 Incoming Ring Group Transfer
Enable (1) or disable (0) each con-
versation tables ability to follow the
Ring Group programming defined in
Program 22-12-01 : DID Intercept
Ring Group.
If Program 22-11-05 : DID Transla-
tion Number Conversion, Transfer
Destination Number 1 and Program
22-11-06 : DID Translation Number
Conversion, Transfer Destination
Number 2 are set, the priority of
transferring is in this order: Program
22-11-05 then Program 22-11-06
then if Program 22-11-11 is enabled,
Program 22-12-01.
If the terminal is in Power
Cutting mode from the ecol-
ogy feature this command
will not be applied.
0 = Disable (Caller will hear Ringback)
1 = Enabled (Go to normal ring)
1
Default
The default value of Programs 22-11-01 and 22-11-02 is shown as below.
Conversion Table Received number Target number
100200
201201
ISSUE 1.0SL1000/SL1100
Program
22
Program 22 : Incoming Call Setup2-256