NEC SL1000 - Page 556

Program No. Name Default
20-17-01 Operator’s Extension number 200 (Operator1=200)
30-02-01 DSS Console Extension Assignment 200 (DSS Console No.1 = 200)
10-02-01 Country Code 56
15-02-01 Display Language Selection 12
40-07-01 Voice Prompt Language Assignment for Sys-
tem based
7
47-02-16 Voice Prompt Language 7
47-06-14 Voice Prompt Language 7
47-07-03 Prompt Language 7
47-10-03 Voice Prompt Language 7
Taiwan
Program No. Name Default Note
15-01-01 Extension Name -
(Delete all station name)
20-02-12 Forced Intercom Ringing 1
21-04-01 Toll Restriction Class for Extensions 1
(Class 1, EXT 200 ~ 295, mode1~4)
21-05-07 Permit code table Class 1 set 1
Class 2 set 2
Class 3 set 3
Class 4 set 4
21-05-08 Restriction table Class 1 set 1
Class 2 set 2
Class 3 set 3
Class 4 set 4
21-06-06 Permit code table PmitTBL 1 = None
PmitTBL 2 = None
PmitTBL 3 = 080, 081
PmitTBL 4 = 110, 119
21-06-07 Restriction table TollRes 1 = 0204
TollRes 2 = 00, 01, 0204, 100, 108
TollRes3=0,100, 18, 108
TollRes4=@
31-02-01 Internal Paging Group Assignment 1
(All stations)
31-02-02 Internal Paging Group Assignment 1
(All stations)
14-02-10 Caller ID 1
(Trunks 1 ~ 27)
14-02-16 Caller ID signal 1
(Trunks 1 ~ 27)
22-04-01 Incoming Extension Ring Group As-
signment
Set to 200-207 (IRG1)
11-09-01 Trunk Access Code 0
11-01-01 System Numbering 0 for Type 3 Trunk access code
9 for Type 5 operator
10-20-01 LAN Setup for External Equipment
(SMDR)
DEVICE 5 set to 1
35-01-01 SMDR-Output Port Type 1
(Port 1 only)
ISSUE 1.0SL1000/SL1100
Program
90
Program 90 : Maintenance Program2-534