NEC SL1000 - Page 88

Item No. Item Terminals Default
Related Pro-
gram
Note
23 SMDR - Extension Accumu-
lated Printout Code
MLT 721 20-07-18
24 SMDR - Group Accumulated
Printout Code
MLT 722 20-07-19
25 Account Code Accumulated
Printout Code
MLT 723 20-07-20
26 Forced Trunk Disconnect MLT, SLT 724 20-07-11
27 Trunk Port Disable for Out-
going Calls
MLT, SLT 745 20-07-12
32 Set Private Call Refuse MLT, SLT 746 14-01-27
20-07-24
33 Entry Caller ID Refuse MLT 747 20-07-25
34 Set Caller ID Refuse MLT, SLT 748 14-01-27
20-07-25
35 Dial-In Mode Switching MLT, SLT 709 20-07-26
41 Date Setting MLT 789 20-07-30
42 Maintenance Service MLT 743
43 VRS Incoming MLT 878 13-04
15-02-55
44 Cutting the telephone power
Sets the Service Code for
power cutting. (for Administra-
tor)
PRG11-10-44 Input dial is Max
4 (SL1000) 8 (SL1100) digits.
MLT, SLT 831
45 Room Monitor Permit
Sets Service Code (SC) for
Room monitor on/off to termi-
nal.
SC+1+Extension Number ;
Room Monitor enable
SC+0+Extension Number ;
Room Monitor disable
MLT, SLT 710
46 Watch Message Setting
Service Code setting for
Watching message recording
to VRS
MLT, SLT 714
47 Warning Message Setting
Service Code setting for Warn-
ing message recording to
VRS.
MLT, SLT 715
48 Auto Dial Setting for Secu-
rity Sensor
Service Code setting for desti-
nation number when Warning
mode detected.
MLT 717
49 Auto Dial Setting for Remote
Inspection
Service Code setting for desti-
nation number when remote
inspection detects no answer
MLT 719
50 Night-mode Skip (Own
Group)
MLT, SLT 787
MLT = Multiline Terminal
SLT = Single Line Telephone
ISSUE 1.0SL1000/SL1100
Program
11
Program 11 : System Numbering2-66