NEC SL2100 Programming Manual

Program 14 : Trunk, Basic Setup
14-07 : Trunk Access Map Setup
Level:
IN
Description
Use Program 14-07 : Trunk Access Map Setup
to set up the Trunk Access Maps. This sets an
extension access options for trunks. For example, an extension can place only outgoing calls on
trunks to which it has outgoing access. There are 128 Access Maps with all 128 trunk ports
programmed in Map 1 with full access.
An extension can use one of the maps you set up in this program. Use Program 15-06 to assign Trunk
Access Maps to extensions. Each trunk can have one of eight access options for each Access Map.
Emergency calls will override Program 14-07 settings.
Input Data
Access Map Number 1 ~ 128
Item
No.
Item Input Data Description Default
01 Access
Map
0 = No access
1 = Outgoing access only
2 = Incoming access only
3 = Access only when trunk on Hold
4 = Outgoing access and access when trunk on
Hold
5 = Incoming access and access when trunk on
Hold
6 = Incoming and Outgoing access
7 = Full accsess
Trunk Port Number =
001 ~ 128
Refer below
Default
Access map No. Trunk Port No. Default
1 1 7 (T, R, H)
2 7 (T, R, H)
: :
128 7 (T, R, H)
2 1 7 (T, R, H)
2 7 (T, R, H)
: :
128 7 (T, R, H)
ISSUE 2.0 SL2100
Programming Manual 2-125
Program
14

NEC SL2100 Specifications

General

Mounting	Desk/Wall
Handset type	Wired handset
Product type	IP Phone
Product color	Black
Wi-Fi	No
Ethernet LAN	Yes
Networking standards	IEEE 802.3af
Ethernet LAN interface type	Gigabit Ethernet
Number of programmable keys	8
Display resolution	168 x 128 pixels
Lines quantity	- lines
Phonebook capacity	- entries
Number of VoIP accounts	-
Voice codecs	G.711, G.729A
Number of handles included	1 pc(s)
Headphone outputs	1
Ethernet LAN (RJ-45) ports	2