Program 22 : Incoming Call Setup
22-02 : Incoming Call Trunk Setup
Level:
IN
Description
Use Program 22-02 : Incoming Call Trunk Setup to assign the incoming trunk type for each trunk.
There is one item for each Night Service Mode.
Input Data
Trunk Port Number 1 ~ 128
Day/Night Mode 1 ~ 8
Item
No.
Item Input Data Description Default Related
Program
01 Trunk Service
Type
0 = Normal
1 = VRS (second dial
tone if no VRS instal-
led)
2 = DISA
3 = DID
4 = DIL
5 = Tie Line
6 = Delayed VRS
7 = ANI/DNIS
8 = DID (DDI) Mode
Switching
Use this option to set the feature
type for the trunk you are program-
ming.
0
14-04
Conditions
• When connecting to T1 trunks, after changing Program 22-02-01 to match the Telco connected T1
service type, the T1 cable or the T1 board must be unplugged and then reconnected for the T1
board to sync.
• When the trunk type is set to 3 (DID), the DID Transfer to Destination in 22-11-04 for each DID
feature is not supported. This feature is supported only for DID trunks when assigned as VRS.
• When the trunk type is set to 3 (DID), the DID Intercept Destination feature for each DID is not
supported. This feature is supported only for DID trunks assigned as VRS.
Feature Cross Reference
• Central Office Calls, Answering
SL2100 ISSUE 2.0
2-286 Program 22 : Incoming Call Setup
Program
22
To Next Page
Loading...
