Program 10 : System Configuration Setup
10-08 : Pre-Ringing Setup
Level:
IN
Description
Use Program 10-08 : Pre-Ringing Setup to enable or disable pre-ringing for trunk calls. This sets
how a trunk initially rings a telephone. With pre-ringing, a burst of ringing occurs as soon as the trunk
LED flashes. The call then continues ringing with the normal ring cadence cycle. Without pre-ringing,
the call starts ringing only when the normal ring cadence cycle occurs. This may cause a ring delay,
depending on when call detection occurs in reference to the ring cycle.
Input Data
Item
No.
Item Input Data Default
01 Pre-Ringing 0 = Disabled
1 = Enabled
0
Conditions
• Used with Analog Trunks only.
Feature Cross Reference
• Central Office Calls, Answering
SL2100 ISSUE 2.0
2-16 Program 10 : System Configuration Setup
Program
10
To Next Page
Loading...
