Program 21 : Outgoing Call Setup
21-01 : System Options for Outgoing Calls
Level:
IN
Description
Use Program 21-01 : System Options for Outgoing Calls to set the system options for Outgoing
Call Service.
Input Data
Item
No.
Item Input Data Description Default Related
Program
01 Seizure Trunk
Line Mode
0 = Priority Route
1 = Circular Route
Select the trunk based off the Trunk
Route Priority (0) or based off the
trunk that has not been used in the
longest time (1).
0
14-05
14-06
02 Intercom Interdi-
git Time
0 ~ 64800 seconds When placing Intercom calls, exten-
sion users must dial each digit in
this time.
10
03 Trunk Interdigit
Time (External)
0 ~ 64800 seconds The system waits for this time to ex-
pire before placing the call in a talk
state (Call Timer starts after time ex-
pires, Voice Over and Barge-In is
not allowed until after time expires).
5 14-02-08
04 Dial Tone Detec-
tion Time
0 ~ 64800 seconds If dial tone detection is enabled, the
system waits this time for the Telco
to return dial tone. When the time
expires, the system assumes dial
tone is not present. To disable this
time (and have the system wait con-
tinuously), enter 0.
5 14-02-05
05 Disconnect Time
when Dial Tone
not Detected
0 ~ 64800 seconds If 14-02-11 is enabled, the system
skips over a trunk if dial tone is not
detected. This option pertains to
calls placed using Speed Dial, ARS,
Last Number Redial or Save Num-
ber dialed. It does not pertain to line
key or Direct Trunk Access calls.
3
06 Dial Pause at
First Digit
0 ~ 64800 seconds 1
07 Toll Restriction
Override Time
0 ~ 64800 seconds After dialing the Toll Restriction
Override codes, the system re-
moves Toll Restriction from the ex-
tension for this time.
10 20-08-06
21-07
08 Preset Dial Dis-
play Hold Time
0 ~ 64800 seconds 10
09 Ringdown Exten-
sion Timer (Hot-
line Start)
0 ~ 64800 seconds A Ringdown extension automatically
calls its programmed destination af-
ter this time.
5 20-08-09
21-11
SL2100 ISSUE 2.0
2-256 Program 21 : Outgoing Call Setup
Program
21
To Next Page
Loading...
