Program 42 : Hotel Setup
42-06 : PMS Service Setting
Level:
IN
Description
Use PRG 42-06 : PMS Service Setting to set the PMS integration Settings.
Input Data
Item
No.
Item Input Data Description Default
01 PMS Port Number 0 ~ 65535 Determine the TCP port the application
should connect to for the integration
stream.
5129
02 3:00 AM Auto Room
Scan
0 = Off
1 = On
Determine if the system scans the status
of Hotel rooms at 3:00 AM.
0
03 CheckIn Message
Type
0 = Of
f
1 = On
Determines whether a check-in or Out
Message is sent when the action is per-
formed on the PBX.
0
04 CheckOut Auto Sta-
tus Change
0 = Off
1 = On
Determines the room status when a room
is checked out.
0
05 AREYUTHERE/LINET-
EST Send Timing
1 ~ 128 seconds Defines the time that passes after any
PMS message sent from the PBX that the
PBX sends an AREYUTHERE message.
10
06 AREYUTHERE/LINET-
EST Send Count
0 ~ 20 (times) This is the retry count for un-acknowl-
edged AREYUTHERE messages.
3
07 Check-Out Auto Flexi-
ble Status Change
0 = Off
1 = On
When PRG 42-06-07 and PRG 42-06-04
are set to on, the status programmed with
PRG 42-06-08 can be set upon checkout
regardless of the previous status.
0
08 Status for Check-Out
Auto Flexible Status
Change
1 = Room Clean(Occu-
pied)
2 = Maid Required
3 = Maid in Room
4 = Inspection Required
5 = Maintenance Re-
quest
6 = Out of Order
7 = Reserve 1
8 = Reserve 2
9 = Reserve 3
0 = Room Clean(Vacant)
= Reserve 5
# = Reserve 6
When PRG 42-06-07 is set to on, the sta-
tus programmed with PRG 42-06-08 can
be set upon checkout.
4
Conditions
None
SL2100 ISSUE 2.0
2-418 Program 42 : Hotel Setup
Program
42
To Next Page
Loading...
