NEC SL2100 - Dial Analysis Table for ARS;F-Route Access

Program 44 : ARS/F-Route Setup
44-02 : Dial Analysis Table for ARS/F-Route Access
Level:
IN
Description
Use Program 44-02 : Dial Analysis Table for ARS/F-Route Access
to set the Pre-Transaction Table
for selecting ARS/F-Route.
Input Data
Dial Analysis Table Number 1 ~ 200
Item
No.
Item Input Data Description Default Related
Program
01 Dial Up to eight digits
(Use line key 1 for a
Don’t Care digit, @)
Set the number of digits to be ana-
lyzed by the system for ARS routing.
No Setting
02 Service Type 0 = No Setting (None)
1 = Extension Call
(Own)
2 = ARS/F-Route Table
(F-Route)
3 = Dial Extension Ana-
lyze T
able (Option)
• Service Type 1 (Extension Num-
ber)
The number goes to an extension
after deleting the front digit(s).
Additional Data
Assign the digit(s) to be deleted
on top of the number for exten-
sion number usage. At least one
digit must be deleted.
• Service Type 2 (ARS/F-Route)
The number is controlled by
ARS/F-Route table.
Additional Data:
If the ARS/F-Route Time Sched-
ule is not used, assign the ARS/F-
Route table number for Program
44-05.
If the ARS/F-Route Time Sched-
ule is used, assign the ARS/F-
Route selection number for Pro-
gram 44-04.
• Service Type 3 (Dial Extension
Analyze Table)
The total length of the number ex-
ceeds more than 8 digits.
Additional Data:
Assign the Dial Extension Analy-
sis Table number to be used in
Program 44-03.
0 44-02-01
44-03
44-05
ISSUE 2.0 SL2100
Programming Manual 2-425
Program
44