EasyManua.ls Logo

NEC SL2100 - ARS;F-Route Table

NEC SL2100
678 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Program 44 : ARS/F-Route Setup
44-05 : ARS/F-Route Table
Level:
IN
Description
Use Program 44-05 : ARS/F-Route Table
to set the ARS/F-Route table. There are four kinds of
order. If the higher priority trunk groups are busy, the next order group is used. If a lower priority route
is selected, the caller may be notified with a beep tone.
Input Data
ARS/F-Route Table Number 1 ~ 100
Priority Number 1 ~ 4
Item
No.
Item Input Data Description Default Related
Program
01 Trunk Group
Number
0 = No Setting
1 ~ 50 = Trunk group
101 ~ 150 = Network-
ing
255 = Intercom
Select the trunk group number to
use for the outgoing ARS call.
0
02 Delete Digits 0 ~ 255
(255 = Delete All)
Enter the number of digits to be de-
leted from the dialed number.
0 44-05-08
03 Additional Dial
Number Table
0 ~ 100 Enter the table number (defined in
Program 44-06) for additional digits
to be dialed.
0 44-05-08
44-06
04 Beep Tone 0 = Off
1 = On
Select whether or not a beep is
heard if a lower priority trunk group
is used to dial out.
0
05 Gain Table Num-
ber for Internal
Calls
0 ~ 100
0 = No Setting
Select the gain table number to use
for the internal call (defined in Pro-
gram 44-07).
0 44-07-03
44-07-04
06 Gain Table Num-
ber for Tandem
Connections
0 ~ 100
0 = No Setting
Select the gain table number to use
for the tandem call (defined in Pro-
gram 44-07).
0 44-07-01
:
44-07-04
07 ARS Class of
Service
0 ~ 50
0 = No ARS Class (Call
Restricted)
Select the ARS Class of Service to
use for the table. An extension ARS
COS is determined in Program
26-04-01.
0 26-04-01
08 Dial Treatment 0 ~ 15 Select the Dial Treatment to use for
the table. If a Dial Treatment is se-
lected, Programs 44-05-02 and
44-05-03 are ignored and the Dial
T
reatment defined in Program
26-03-01 is used instead.
0 26-03-01
09 Maximum Digit 0 ~ 36 Input the maximum number of digits
to send when using the F-Route.
0
11 Network Speci-
fied Parameter
Table
0 ~ 16 Enter a table number from Program
26-12.
0
SL2100 ISSUE 2.0
2-430 Program 44 : ARS/F-Route Setup
Program
44

Table of Contents

Other manuals for NEC SL2100

Related product manuals