NEC SL2100 - SIP System Information Setup

Program 10 : System Configuration Setup
10-28 : SIP System Information Setup
Level:
SA
Description
Use Program 10-28 : SIP System Information Setup to set up basic SIP trunking.
Input Data
Profile 1 ~ 6
Item
No.
Item Input Data Description Default
01 Domain Name Up to 64 Characters
(ex. : UserID@Host-
Name.DomainName)
Set the domain name of the SIP-URL. No Setting
02 Host Name Up to 48 Characters
(ex. : UserID@Host-
Name.DomainName)
Set the host name of the SIP-URL. No Setting
03 Transport Protocol 0 = UDP
1 = TCP
2 = TLS (V2.0 or higher)
Set the protocol for the connection. 0
05 Domain Assignment 0 = IP Address
1 = Domain Name
If the information from Telco was a domain
name (siptrunk@sip.com) then set to do-
main. If the information for Telco was a IP
address then set to IP Address.
0
06 IP T
runk Port Binding 0 = Disable
1 = Enable
Trunk port binding is only used for SIP
trunks to the provider in Non-Registration
Mode only. When this is disabled, an in-
bound call comes in and follows your DID
routing but it comes in on the first available
trunk. When enabled, the inbound call
comes in and follows your normal DID
routing but maps to that specified trunk. If
that trunk is busy, it sends back a busy un-
less you build a hunt group. To build the
hunt group, it references command
14-12-02 (pilot register ID). This then
points you to command 10-36-02. All the
numbers with the same pilot are in the
same hunt group.
0
Conditions
None
Feature Cross Reference
None
SL2100 ISSUE 2.0
2-32 Program 10 : System Configuration Setup
Program
10