NEC SL2100 - Copy Program by Port Number

Program 92 : Copy Program
92-03 : Copy Program by Port Number
Level:
IN
Description
This program is available only via telephone programming and not through PC Programming.
Use Program 92-03 : Copy Program by Port Number to copy extension and the data of each
outside line.
Input Data
Program Number XX-XX
Item No. Item Input Data Description
01 Source Number • For Trunk Base : Trunk Port Number
1 ~ 128
• For T
runk Group Base : Trunk Group
Number 1 ~ 50
• For Extension Number : 1 ~ 128
• For Department Group Base : De-
partment Group Number 1 ~ 50
• For DSS : (DSS Console Number 1 ~
12
Enter the port number from where
the data is to be copied.
02 Destination Number (From) Enter the first port number to
where the information is to be
copied
03 Destination Number (To) Enter the last port number to
where the information is to be
copied. If the information is to be
copied only to one port, enter the
information entered in the Desti-
nation Number (From) entry.
Refer to Program 92-01 Copy Program on page 2-
636 for program that can be copied.
Conditions
None
Feature Cross Reference
None
SL2100 ISSUE 2.0
2-640 Program 92 : Copy Program
Program
92