Item
No.
Item Input Data Description Default Related
Program
03 Internal Incom-
ing Ring Tone
1 = High (
2W Digital, IP
Multiline Terminal)
2 = Medium (2W Digi-
tal, IP Multiline Termi-
nal)
3 = Low (2W Digital, IP
Multiline Terminal)
4 = Melody 1 (2W Digi-
tal, IP Multiline Termi-
nal)
5 = Melody 2 (2W Digi-
tal, IP Multiline Termi-
nal)
6 = Melody 3 (2W Digi-
tal, IP Multiline Termi-
nal)
7 = Melody 4 (2W Digi-
tal, IP Multiline Termi-
nal)
8 = Melody 5 (2W Digi-
tal, IP Multiline Termi-
nal)
Use this option to set the tone
(pitch) of the incoming extension call
ring for the extension port you are
programming. Also refer to Program
15-08.
8
04 Redial (Speed Di-
al) Control
0 = Common and Indi-
vidual Speed Dialing
1 = Group Speed Dial-
ing
Use this option to control the func-
tion of the extension Redial key
when used with Speed Dialing. The
Redial key can access either the
Common/Individual or Group Speed
Dialing numbers.
0
05 Transfer Key Op-
eration Mode
0 = Transfer
1 = Serial Call (call
back)
2 = Hook (Flash)
Use this option to set the operating
mode of the extension Transfer key.
The keys can be for Call Transfer,
Serial Calling or Flash. When select-
ing the Flash option (selection 2),
refer also to Program 81-01-14.
0
06 Hold Key Operat-
ing Mode
0 = Normal Hold
1 = Exclusive Hold
Use this option to set the function of
the Multiline Hold key. The Hold key
can activate normal Hold or Exclu-
sive Hold.
0
07 Automatic Hold
for CO Lines
0 = Hold
1 = Disconnect (Cut)
When talking on a CO call and an-
other CO line key is pressed, the
original trunk is placed on Hold (0)
or Disconnected (1).
1
08 Automatic
Handsfree
0 = Preselect
1 = One-Touch (Auto-
matic Handsfree)
Use this option to set whether
pressing a key access a One-Touch
Key or if it preselects the key.
1
10 Ringing Line
Preference for
Trunk Calls
0 = Idle (Off)
1 = Ringing (On)
Use this option to select between
Idle and Ringing Line Preference for
trunk calls.
1
11 Callback Auto-
matic Answer
0 = Off
1 = On
Use this option to enable or disable
automatic answer of calls recalling
to a station. For example, if a Trans-
fer Recall or Hold Recall is ringing
back to a station, the following hap-
pens:
If Program 15-02-11 is enabled, the
station will automatically answer the
recall when it goes off-hook. If Pro-
gram 15-02-11 is disabled, a station
does not automatically answer the
recall when it goes off-hook. The
user must first press the line ap-
pearance of the recalling call or
press the answer key.
1
ISSUE 2.0 SL2100
Programming Manual 2-135
Program
15
To Next Page
Loading...
