Item
No.
Item Input Data Description Default Related
Program
09 Caller ID Func-
tion
0 = Disable (Caller ID
not displayed.)
1 = Enable (Caller ID is
displayed.)
Enable (1) or disable (0) the Caller
ID FSK signal for an external Caller
ID module or a 3rd party vendor tel-
ephone with Caller ID display.
Important:
If voice mail is used, this setting
must be disabled for the system in-
tegration codes to be correct.
With a Single Line Telephone,
this must be set to 0 for incoming
callers to have a talk path.
0
10 Caller Name 0 = Disable
1 = Enable
Determine if an extension user tele-
phone should display the Caller
name.
1 15-03-09
12 Fixed Cadence 0 = Normal
1 = Fixed
1
13 MW sending type 0 = Lamp
1 = Caller ID
0
14 Forwarded Caller
ID Display Mode
0 = Calling Extension
Number (Calling)
1 = External Caller ID
(Forward)
Determine what the display shows
when a multiline terminal receives a
forwarded outside call.
0
15 Disconnect with-
out dial after
hooking hold
0 = Normal
1 = Disconnect
Determine whether or not to discon-
nect a held call when on-hook with-
out any dialing after hooking-hold.
0
16 Special DTMF
Protocol Send
0 = No
1 = Yes
Determine whether or not to send
the extension number of the phone
forwarded to the extension when
Program 15-03-04 is set to Special
(1) and not in the VM group.
0
45-01-16
18 Select Special
Terminal Type
0 = Fax
1 = Modem
This PRG is used for selecting Spe-
cial Terminal Type (Fax or Modem).
This setting influences how to trans-
mit data via SIP trunk. This PRG is
effective at the time of when
PRG15-03-03 1: Special.
0 15-03-03
19 Door Phone
Number
Do not set
the same
door phone
number as
PRG10-03-0
5 (SLIU).
1 ~ 6 Set the SLT door phone number.
When unlocking the door PRG10-61
will be in effect.
0
10-03-05
(SLIU)
10-61
SL2100 ISSUE 2.0
2-142 Program 15 : Extension, Basic Setup
Program
15
To Next Page
Loading...
