Item
No.
Item Input Data Description Default
01 Received Number Maximum eight digits
(0 ~ 9,
, #, @)
This is the received DID digits. No Setting
02 Target Maximum 36 digits
(0 ~ 9,
, #, @)
Enter the destination number to which the
DID number is sent.
No Setting
03 DID Name Maximum 12 characters This is the name that is assigned to the
DID digits when it rings the extension.
No Setting
04 Transfer Operation
Mode
0 = No Transfer
1 = Busy
2 = No Answer
3 = Busy/No Answer
The transfer operation mode allows DID
calls to have more routing options than just
the target number. If the transfer operation
mode is set to "No T
ransfer" calls will only
be delivered to the Target Number speci-
fied in PRG 22-11-02. If set to one of the
three other modes, it will follow that mode
through all assigned transfer destinations.
0
05 Transfer Target 1 0 = No Setting
01 ~ 50 = Incoming Ring
Group
101 = Not Used
102 = InMail
103 = Centralized VM
201 ~ 250 = Department
Group
400 = VRS
401 = DISA
501 ~ 599 =Valid Exten-
sion Number/VRS Mes-
sage
1000 ~ 1999 = Common
ABB Dial (000 ~ 999)
0
06 Transfer Target 2 0 = No Setting
01 ~ 50 = Incoming Ring
Group
101 = Not Used
102 = InMail
103 = Centralized VM
201 ~ 250 = Department
Group
400 = VRS
401 = DISA
501 ~ 599 = Valid Exten-
sion Number/VRS Mes-
sage
1000 ~ 1999 = Common
ABB Dial (000 ~ 999)
400 - Allow the outside party to dial a dif-
ferent extension number in the translation
table (for example, ring no answer to a di-
aled number, the caller then hears a dial
tone, allowing them to enter another Valid
Extension Number).
401 - Provide the caller with DISA dialing
options (requires using the DISA pass-
word).
This applies to 22-11-05 and 22-11-06.
0
07 Call Waiting 0 = Disable (No)
1 = Enable (Yes)
Program 20-09-07 overrides this setting. 0
08 Maximum Number of
DID Calls
0 ~ 128 (0 = No limit)
Per DID translation table a DID can be
limited to only accept a certain amount of
calls. If a call is delivered to the system
when the limit has been reached, the out-
side caller will receive a busy tone.
0
09 Music on Hold Source 0 = IC/MOH Port
1 = BGM Port
0
SL2100 ISSUE 2.0
2-298 Program 22 : Incoming Call Setup
Program
22
To Next Page
Loading...
