-116-
5. Drive Replacement
It is used at the time of the maintenance work of a drive.
1) Check Remove of the drive to exchange and click Execute.
2) Remove a drive.
3) Attach the drive of service parts.
When you take over to the drive after exchanging the drive serial number before exchange, a
case checks.
4-1)Restore, and put a check into Succeed Serial Number, and click Execute.
When you do not take over to the drive after exchanging the drive serial number before
exchange, check
4-2)Restore, and click Execute.
[Case where are before and after exchange and a drive serial number is
not changed]
The work of a drive new recognition, by backup software becomes
unnecessary.
However, since the serial number indicated to the drive itself differs from
the drive serial number which can be checked with an operator panel or a
remote administration interface, cautions, such as the time of
maintenance, are needed.
[Case where are before and after exchange and a drive serial number is
changed]
The work of a drive new recognition, by backup software is needed.
[Being related with the save of a configuration file].
Please prepare for emergency and usually save a configuration file
periodically from the time of use.
To Next Page
Loading...
