-26-
1.8 Removal of shipment Stabilizer
The Library has a screw that is fastened to its rear side to stabilize the internal Accessor during
shipment.
Before using the Library, be sure to unfasten this screw.
Make sure that the shipment stabilizer screw has been unfastened.
If the power is turned on while the screw is still fastened, operation faults may
occur
If the error message "***CHK*** CODE:[0009]" is displayed, turn off the power and
unfasten
this shipment stabilizer screw before turning the power back on.
To Next Page
Loading...
