NEC T30A - Network Settings; Table 4-14 Network Setting Submenu; Table 4-15 Ipv4 Setting Submenu; Table 4-16 Ipv6 Setting Submenu

-50-
4.4.2.2 Network Settings
Table 4-14 Network Setting Submenu
Submenu item
Default
Description
Link Speed
Auto Negotiation
This sets the network's communications mode.
To use the auto setting, select "AUTO".
Protocol Stack
IPv4 Only
Setting of Protocol Stack
IPv4 Setting
-
Setting of IPv4 network
IPv6 Setting
-
Setting of IPv6 network
Table 4-15 IPv4 Setting Submenu
Submenu item
Default
Description
DHCP IPv4
Disable
This submenu can be used to configure the DHCP
server.
IP Address
192.168.1.1
This sets the IP address for access via a network.
Subnet Mask
255.255.255.0
This enables the Autoloader to be accessed from a
subnet.
Gateway
192.168.1.254
This indicates a gateway connection between subnets.
Apply
-
The above-mentioned setting is applied.
Table 4-16 IPv6 Setting Submenu
Submenu item
Default
Description
Stateless DHCP
Disable
This submenu can be used to configure the stateless
DHCP.
DHCP IPv6
Disable
This submenu can be used to configure the DHCP
server.
IP Address
0::0
This sets the IP address for access via a network.
Plefix length
64
This sets plefix length.
Gateway
0::0
This indicates a gateway connection between subnets.
Apply
-
The above-mentioned setting is applied.