-160-
9.2 Diagnosis test
The operation of the library unit and of individual drive units can be tested by using the library’s
Diagnostics menu.
For details about diagnostic testing, see “4.4.4.2Diagnostics”.
1) [Login]. See Section 4.3Login for detail.
2) Select [Commands].
3) Select [Diagnostics] from [Commands].
4) The library device can be diagnosed by [Library Verify]. The drive unit can be diagnosed by
[Drive Diagnostics].
5) When selecting [Drive Diagnostics], select the detailed test.
6) If error indicator is lighted in the diagnosis, then contact your service representative.
When detecting it abnormally, an error code is shown to an operator panel,
so please push Enter button to advance check movement first after confirmation.
A special diagnostic medium is needed for the diagnostic test.
Do not use the user medium for the diagnostic test.
9.3 Cleaning of device
Please contain water or the detergent in a soft cloth and wipe the dirt of externals lightly.
Before cleaning the library, be sure to turn the power off and unplug the power cable
from the outlet. If you clean the interior of the library with the power turned on, your
fingers may become caught or stuck in moving parts, resulting in injury.
If you wipe the library with volatile chemicals such as benzine or paint thinner, the
library exterior might be damaged or become discolored. This also applies if the
library is sprayed with insecticide.
To Next Page
Loading...
