NEC T30A - Commands; Table 4-11 Commands Submenus

-47-
4.4.1 Commands
Use the COMMANDS menu when moving the cartridge in the library or cleaning the drive through
operator panel.
Table 4-11 Commands Submenus
Submenu item
Default
Description
Move Cartridge
-
Use this menu to move a cartridge in a slot to another slot of
the library.
Specify the slot type and slot numbers of source and
destination slots.
Unload
-
Use this menu to unload the cartridge from the drive.
In addition, it is necessary to execute Move Cartridge to return
it to the slot.
Clean Drive
-
Use this menu to provide cleaning on the drive.
Cleaning cartridge must be loaded beforehand.
See Section 4.8.1 for details.
Shipping Move
-
To carry the library, moves the robot to the carriage position.
Note: Take all the cartridges out from the magazine before
running this command. Before carrying the library, always run
this command.
After executing this command, be sure to fasten the Accessor
using the stabilizer screw.
Reboot Drive
-
This reboots the drive.
See Section4.10 for details.
Reboot Library
-
This reboots the Library.
Library State
■Online
□Offline
Online
This submenu can be used to switch the Library state between
online and offline.
See Section 4.5.4 for details.
Drive State
Online
This submenu can be used to switch the Drive state between
online and offline.
Warning Clear
-
When turning it off when the lighting Alarm indicator is
recovered from the error situation, it selects it.