SECTION 5
DISASSEMBLY AND ASSEMBLY
95
10. Remove the Shaft. Remove Belt(s).
11. Remove (2) screws [H]
securing Bracket
Assembly to Belt(s).
12. Reassemble in reverse
order. NOTE:
Remember to reinstall
the Lift Belt Clamp
Bracket on the new
Belt. Make sure the
Brackets are oriented
correctly depending on
which side the Belt is
being installed. Loop
Belts over the Drive
Shaft before installing
the Drive Shaft in the
Printer. Pass the Drive
Shaft through the two
Ink Hose wire ties.
Reinstall the outer small
Lift Drive Belt.
IMPORTANT: Align the Printhead Locator Assembly with the
Printer using a level. Make sure the Printer is on a flat, level
surface. Perform fine levelling of the Printhead Locator by
adjusting the Lift Belt Bracket on the Non-Operator side of the
Printer. Loosen the (2) mounting screws [A] to move the Bracket
up and down slightly until the Printhead Locator Assembly is
level in the Printer. If the Printhead is not level it will cause
printing problems and not align with the Service Station Capping
Station correctly, which can affect Printhead service life.
Check/adjust tension on the Belt(s). See “Printhead Lift
Assembly Belts Tension Adjustment” in the Adjustments Section.
System Test: Press Printhead Test.
To Next Page
Loading...
Need help?
General
