SECTION 6
MAINTENANCE
124
Capping Station:
1. Using the Touchscreen, select “Menu,” and tap
“Maintenance” from the drop-down menu. Tap
“Inspect Sled”. The Service Station moves out
from under the Printhead Assembly.
2. Open the Top Cover.
3. Gently release the tabs [A] (one located at each
end) securing the Assembly to the Service
Station Base.
4. Lift the Capping Station [B] out of the Printer.
NOTE: Be careful, watch for dripping ink.
Do not lose the (2) inserts the Capping Station
rests on (located behind the release tabs).
5. Cleaning:
Clean off ink
buildup and
debris with
distilled water
and replace in
the Service
Station Tray.
6. Install in reverse order.
Service Station Tray:
1. Remove Wiper Roller Assembly
and Capping Station.
2. Cleaning: Wipe Tray with a
clean, damp, lint-free cloth.
NOTE: Be careful not to get
any nearby electrical
connections or PC Boards wet.
Replace Ink Waste Tray
Ink Tray soaks up any excess ink that may drip from Print Engine during operation. After a period of time it may
become saturated and need replacement.
1. Open Ink Tank Door.
2. Pull on tabs to slide Ink Waste
Tray [A] out of Printer.
3. Replace with a new Ink
Waste Tray.
To Next Page
Loading...
Need help?
General
