SECTION 5
DISASSEMBLY AND ASSEMBLY
68
Replace Feed Roller Assemblies
Follow the steps below to remove the Rear [1], Middle [2] and Front [3] Feed Roller Assemblies:
1. Remove the Left Operator Side
Cover and the Non-Operator Side
Cover.
2. Remove the Separator Assembly.
3. Remove the Center Plate Assembly.
4. Loosen the Feed Motor mounting
screws [A] to release tension on the
Drive Belt.
5. Remove the Clutch and Pulley
Assemblies [B].
6. Remove (2) screws [C] securing the Bearing Housings to Side
Frames (3 Bearing Housings on each side).
7. Remove Brake Assembly [D] from the mounting stud by removing
the C-clip.
8. Remove the Feed Roller(s) from the Printer.
9. Install in reverse order. Remember to reinstall the Brake
Assembly and Feed Roller Belts. NOTE: Check/adjust tension on
the Feed Motor Drive Belt. See “Feed Roller Belt Tension
Adjustment” in the Adjustments Section. System Test: Press
Feeder Test.
IMPORTANT
When installing the unidirectional rimless pulleys
(roll CCW, will not roll CW) on the Middle or Front
Feed Shafts, note the numbers etched into the
bearing races:
Middle Feed Shaft: The numbers should face
toward the shaft rollers.
Front Feed Shaft: The numbers should face away
from the shaft rollers.
To Next Page
Loading...
Need help?
General
