SECTION 1
INTRODUCTION
9
Connect Printer
Plugging in Printer
Plug power cord into receptacle [1] at rear of Printer. Internal power supply in
Printer is rated 115 to 240VAC, 50/60 Hz.
CAUTION
DO NOT USE AN ADAPTER PLUGS OR EXTENSION CORDS
TO CONNECT PRINTER TO WALL RECEPTACLE.
DO NOT USE OUTLETS CONTROLLED BY WALL SWITCHES.
DO NOT USE OUTLETS THAT SHARE SAME CIRCUIT WITH
LARGE ELECTRICAL MACHINES OR APPLIANCES
.
Connect to Computer
Printer connects to computer through USB Port [2].
Network Port [3] for operating in a network environment.
See “Network Connection Setup” in “Using Control Panel Touchscreen”.
Turning Power ON and OFF
IMPORTANT! START ONE PRINTER AT A TIME WHEN SIMILAR
PRINTERS ARE ON THE SAME NETWORK.
Powering Up Printer:
1. Press Main Power Switch on Rear Panel.
2. Press Power Button on Control Panel.
Powering Down Printer:
CAUTION
WHENEVER POWERING DOWN UNIT, ALWAYS:
1. PRESS POWER BUTTON ON CONTROL PANEL.
2. WAIT FOR PRINTER TO STOP PROCESSING.
3. THEN PRESS MAIN POWER SWITCH ON REAR PANEL.
To Next Page
Loading...
Need help?
General
