SECTION 1
INTRODUCTION
1
SECTION 1 – Installing Printer
Before using Printer:
Transport Inspection. Upon delivery, inspect packaging and report any issues to the Carrier.
Gather Tools
Choose a location for Printer
Unpack and verify Accessory Box contents
Attach Media Guide to Printer
Remove shipping materials – Shipping Tape???
Install Print Platen & Drip Tray Assembly
Plug in Printer
Install Printer Software (Driver & Toolbox). Then connect Printer to Computer.
Install Ink Tanks
Install Printhead
Set up feed on Printer
Transport Inspection
The printer is shipped in appropriate packaging so that, under normal shipping conditions, it reaches its destination
without damage.
NOTICE: Report damage to the carrier. The carrier is liable for any damage during transport.
Transport and storage should take place under the following conditions:
-
At temperatures between -25°C and +50°C (-13 °F to 122 °F).
-
At a relative air humidity between 5% and 95%, non-condensing.
-
At an atmospheric pressure between 70 kPa and 105 kPa.
Exposure to conditions that are not permissible may lead to damage which is not externally visible.
IMPORTANT Please save packaging materials for future use! It will be required if you ever need to ship printer.
Before shipping; please refer to the section titled “Preparing Printer for Transport”.??
Tools Needed
Knife and scissors to open packaging
Carpenters Level
#2 Philips Screwdriver
Protective, nitrile powder-free gloves should be worn to avoid getting ink on hands when installing
Print Platen and Drip Tray Assembly, Printhead Cartridge and Ink Tanks.
Distilled or de-ionized water
Non-abrasive, lint free cloths
To Next Page
Loading...
Need help?
General
