SECTION 6
MAINTENANCE
125
Replace Sheet Separators
Sheet Separators insure separation of pieces as they are fed. If experiencing double sheet feeding and cannot adjust
Separators to prevent it, replace them.
To replace Sheet Separators:
1. Turn Printer OFF and unplug it from power source.
2. Release Separator-by loosening Locking Knob and
moving Media Side Guides to maximum opened
position.
3. Lower Separators so they touch Feed Roller.
4. Remove screw [A] and Separator Cover [B]. Remove
Separator [C] by prying it out of Holder.
5. Install a new Separator and reinstall Separator Support
and screw.
DO NOT overtighten screw to prevent distorting or
damaging Separator.
To Next Page
Loading...
Need help?
General
