SECTION 6
MAINTENANCE
127
[A] Media Sensors:
Paper lint and dust
may build up on
Media Sensors. Use a
can of compressed air
or a damp (not wet)
foam or lint-free
cotton swab to gently
swab Sensors. Take
care not to drip water
into Circuit Boards.
Use a clean, dry swab
to dab surfaces dry.
[B]. Rubber Rollers and Conveyor Belts.
Clean as needed using distilled water with a damp,
lint-free cloth.
NOTE: Be careful not to splash or drip ink on other
parts of Printer.
[C] Printing Surfaces, Ink Drip Cover and Tray.
Wipe using distilled water and a damp, lint-free cloth.
Pat dry with a lint-free cloth. Ink Drip Tray: Carefully remove Ink Drip Tray Cover and Ink Drip Tray.
DO NOT tip the Tray or ink may spill. Wipe off excess ink then clean using distilled water and a damp, lint-
free cloth.
Clean Ink Revolver Couplings
1. First Deprime the system and remove the
Printhead Cartridge.
2. Moisten a foam swab in distilled water.
3. Insert the swab into one of the ink channels and
rotate swab to clean chamber.
4. Use a new swab for each of remaining ink channels
until all 10 openings are clean. (5 on each side.)
To Next Page
Loading...
Need help?
General
