SECTION 4
ADJUSTMENTS
39
Non-Operator Side:
1. Loosen the Service Station Belt Tensioner Pulley [A]
(1 screw). NOTE: This will release tension on both
the Service Station Motor Drive Belt and the
Positioning Belt. When adjusting this Belt you will
need to recheck and retension the Service Station
Motor Drive Belt.
2. Move Service Station Belt Tensioner Pulley up or
down to tension both the Motor Drive Belt [B] and
Positioning Belts [C]. When properly tensioned, there
should be about 1/8" of deflection in the Belts. Move
the Belt back and forth to reset the Belt position and
check for additional slack. Recheck and retension the
Belt as necessary.
NOTE: This adjustment is only an approximation,
further adjustment may be necessary. See “Testing
Belt Tension” at the end of this section. System Test:
Press Sled Test.
3. Tighten the Service Station Belt Tensioner Pulley
screw.
4. Reinstall Covers and close Top Cover.
To Next Page
Loading...
Need help?
General
