Nokia 7210 SAS-Mxp - Page 208

7210 SAS-MXP, R6, R12, S, SX, T BASIC SYSTEM
CONFIGURATION GUIDE RELEASE 22.9.R1
Boot options
Keyword to set the link to 10 M/bps speed.
100
Keyword to set the link to 100 M/bps speed.
1000
Keyword to set the link to 1000 M/bps speed (applicable only to 7210 SAS-R6 and
7210 SAS-R12).
host-type
Syntax
host-type host-type
no host-type
Context
bof
Platforms
7210 SAS-Mxp, 7210 SAS-Sx/S 1/10GE (standalone and standalone-VC), and 7210 SAS-Sx 10/100GE
Description
This command configures the host system.
When operating in satellite mode, the setting for the host-type BOF parameter must be consistent with the
value of the chassis-role parameter; otherwise, on reboot the node will not boot up correctly. See BOF
chassis-role and host-type parameters for 7210 SAS-Mxp, 7210 SAS-Sx 1/10GE, 7210 SAS-S 1/10GE,
and 7210 SAS-Sx 10/100GE for more information.
It is not necessary to configure the host-type value when the chassis role is set to standalone.
For nodes that are destined to operate in a virtual chassis (VC) set up, it is not necessary to configure the
host-type value when the bootloader chassis-role parameter is set to standalone-vc.
The no form of this command removes the host-type setting.
Default
no host-type
Parameters
host-type
Specifies the value of the host type for the system.
Values satellites | standalone | standalone-vc
satellites
The node boots up in satellite mode when the host-type parameter is set to satellites and
the chassis-role is set to satellite or factory-default.
standalone
3HE 18197 AAAB TQZZA
© 2022 Nokia.
Use subject to Terms available at: www.nokia.com/terms/.
208
SPACER TEXT