HOTSPOT GATEWAY
100 System Administration
z Enter a valid IP address in the Subnet Mask field. The subnet mask
defines the number of IP addresses that are available on the routed
subnet where the HSG is located.
z Enter a valid default gateway IP address in the Default Gateway field.
The default gateway is the IP address of the router that the HSG uses
to transmit data to the Internet.
6. When finished, you must reboot the system for the new settings to take effect.
Click the check box for Reboot after changes are saved? to reboot the system
after saving your changes.
7. Click Submit to save your changes and reboot the system, or click Reset to reset
all the values to their previous state.
The network interface and subscriber interface addresses must be on the
same subnet.
To Next Page
Loading...
