HOTSPOT GATEWAY
System Administration 187
Setting Up an X over Y Billing Plan
1. If required, click on the Enable check box to enable (make active) this billing
plan.
2. Define a “label” for this billing plan in the Label field.
3. Enter a description for this billing plan in the Description of Service field.
4. Enter the cost the plan in the Plan Cost field.
5. Enter a duration value for this plan in the Plan Duration (X) field.
6. Define the “time unit” for the duraction value you entered in Step 5. The time
unit can be defined as either
Minute, Hour, or Day.
7. Enter plan validity value for this plan in the Plan Validity (Y) field.
8. Define the “time unit” for the plan validity value you entered in Step 7. The time
unit can be defined as either Day, Week, or Month.
9. Define the Up (to network) and Down (to subscribers) bandwidth range for this
billing plan.
10. Define the DHCP Pool (public or private) -- see following note.
11. Click on the Submit this Plan button to save your changes and establish this
billing plan. Alternatively, you can click on the Delete this Plan button if you
want to delete this plan, or click on the
Reset button if you want to reset all the
values to their previous state.
12. Click on the Back button at any time to return to the Internal Billing Options
Setup (previous) screen.
Each plan must have a unique label, different from other plans.
The “public” option requires IP Upsell to be turned on, otherwise
subscribers will receive private IP addresses.
To Next Page
Loading...
