HOTSPOT GATEWAY
System Administration 69
13. You can assign a session idle timeout parameter for subscribers (see following
note). To assign an idle timeout, simply enter a numeric value (in seconds) in the
Subscriber Idle Timeout box (the default is 1200).
14. If you enabled or disabled SSL Support on this screen, you must click the check
box for
Reboot after changes are saved? (the HSG must be rebooted every
time the SSL Support feature is enabled or disabled).
15. Click on the Submit button to save your changes, or click on the Reset button if
you want to reset all the values to their previous state.
Enabling AAA Services with an External Web Server
You are here because you want to enable the AAA Services with an External Web
Server (EWS). In the EWS mode, the HSG redirects the subscriber’s login request to
an external server.
1. Select the External Web Server.
After enabling the External Web Server you must enter a Secret Key. The Secret
Key ensures that the response the HSG gets from the EWS is valid.
2. Enter the Secret Key (The HSG and the external authorization server must use
the same secret key).
3. Enter the IP Address for the External Web Server.
4. Enter a valid External login page URL.
5. You can assign a session idle timeout parameter for subscribers (see following
note). To assign an idle timeout, simply enter a numeric value (in seconds) in the
Subscriber Idle Timeout box (the default is 1200).
6. Click on the Submit button to save your changes, or click on the Reset button if
you want to reset all the values to their previous state (making changes to the
EWS settings does not require a system reboot).
Subscriber Idle Timeout does not apply to RADIUS subscribers.
DNS must be configured if you want to enter meaningful URLs instead
of numeric IP addresses into any of the HSG’s configuration screens
(for example, the External login page URL in the following step).
Subscriber Idle Timeout does not apply to RADIUS subscribers.
To Next Page
Loading...
