HOTSPOT GATEWAY
System Administration 227
Establishing Login Access Levels {Login}
This procedure shows you how to assign differentiated access levels for operators and
managers at login.
The HSG allows you to define 2 concurrent access levels to differentiate between
managers and operators, where managers are permitted read/write access and
operators are restricted to read access only. Once the logins have been assigned,
managers have the ability to perform all write commands (Submit, Reset, Reboot,
Add, Delete, etc.), but operators cannot change any system settings. When this feature
is enabled, one manager and three operators can access the HSG at any one time (the
default is “disabled”). This feature supports the following interfaces:
z Telnet
z Command Line Interface (CLI) – serial
z Web Management Interface (WMI)
z FTP (no operator access allows)
Only managers can assign a username and password for the remote RADIUS testing
login option.
1. From the Web Management Interface, click on System, then Login.
To Next Page
Loading...
