HOTSPOT GATEWAY
System Administration 217
Deleting an ARP Table Entry {ARP Delete}
ARP (Address Resolution Protocol) is used to dynamically bind a high level IP
address to a low level physical hardware (MAC) address. ARP is limited to a single
physical network that supports hardware broadcasting. This procedure shows you
how to delete an ARP table entry.
1. From the Web Management Interface, click on System, then ARP Delete.
The Delete ARP Table Entries screen appears:
2. Enter the IP address of the entry you want to delete.
3. Click on the Delete button to delete this entry, or click on the Reset button if you
want to reset the “IP Address” value to its blank state.
To Next Page
Loading...
