HOTSPOT GATEWAY
Installing the HSG 31
Installation Workflow
This flowchart illustrates the steps that are required to install and configure the HSG
successfully. Review the installation workflow before attempting to install the HSG
on the customer’s network.
Place the HSG on a flat and stable work surface and connect the power cord.
Start a HyperTerminal session to communicate with the HSG via the serial port.
Power up your computer and turn on the HSG.
Log in to the Command Line Interface.
When prompted, configure your HSG’s IP, DNS, and Location
settings. The HSG will then prompt you to reboot the system.
Connect the HSG to the customer’s network.
Power up the HSG and log in via a Telnet session or the Web Management Interface.
Set the basic configuration parameters for subscribers.
Network
Connect the HSG to a “live” network. Use the DB9 serial cable (6 ft.
length) between the HSG’s serial port and your computer.
Export your configuration settings to an archive file.
The HSG is now ready for administrators to add, delete, or
change unique subscriber profiles.
When prompted, accept to the Nomadix End User License Agreement (EULA). You must
accept the EULA before the HSG can connect with the Nomadix License Key Server. When
the key is successfully received from the server, your HSG will reboot. You can now power
down and connect the HSG to the customer’s network.
To Next Page
Loading...
