HOTSPOT GATEWAY
Installing the HSG 33
Logging In to the Command Line Interface
Use this procedure to initialize the system and log in to the HSG’s Command Line
Interface (CLI). The character-based CLI is used at initial start-up.
1. Start a HyperTerminal™ session to connect to the HSG. Use the following
HyperTerminal settings:
2. When connected to the HSG, a login prompt appears on your screen.
The default login user name is “admin.” The password is “admin.” Login names
and passwords are case-sensitive.
3. Enter admin when prompted for a user name and password. The HSG Menu
appears when you have logged in to the HSG’s management interface
successfully. If this is an initial installation which requires the HSG to receive a
license key from the Nomadix License Key Server, you must accept the
Nomadix End User License Agreement (EULA).
Bits per second 9600
Data bits 8
Parity None
Stop bits 1
Flow control None
To Next Page
Loading...
