HOTSPOT GATEWAY
System Administration 237
Deleting Static Ports {Static Port-Mapping Delete}
Static Port-Mapping allows the network administrator to setup a port mapping
scheme that forwards packets received on a specific port to a particular static IP
(typically private and mis-configured) and port number on the subscriber side of the
HSG. The advantage for the network administrator is that free private IP addresses
can be used to manage devices (such as Access Points) on the subscriber side of the
HSG without setting them up with public IP addresses.
This procedure shows you how to add static ports.
1. From the Web Management Interface, click on System, then Static Port-
Mapping Delete.
The Delete Static Port-Mapping Entries screen appears:
2. Enter the External IP Address and/or the External Port of the item you want to
delete.
3. Click on the Delete button to delete the static port, or click on the Reset button
to reset your changes to their previous state.
For more information about Static Port-Mapping, see also:
z “Displaying the Static Port Mapping Table {Static Port-Mapping}” on
page 146.
z “Adding Static Ports {Static Port-Mapping Add}” on page 235.
To Next Page
Loading...
