HOTSPOT GATEWAY
Appendix B: Addendum 313
B
Appendix B: Addendum
This Addendum provides information and procedures that will enable system
administrators to configure and use the specific features introduced in the 1.3
Maintenance, 1.3 M+ and 1.4 releases for the Nomadix HotSpot Gateway (HSG).
The features covered are
1.3M and 1.3M+ Features:
z PPPoE Client
z L2TP Tunneling
z Local Syslog and Syslog Filters
PPPoE Client
These settings can be accessed under the following menus:
WMI Configuration
z Go to Configuration->Location to enable PPPoE Client
z On Location page, click on ‘Configure PPPoE Client’ link to get to the
PPPoE configuration page.
CLI Configuration
z – Go to Configuration->Location to enable PPPoE Client
z – Go to Configuration->PPPoeclient to configure PPPoE Client
SNMP Configuration
z Go to ag->pppoeClient (enterprises.3309.1.3.43) for PPPoE Client
configuration branch
z Go to ag->location (enterprises.3309.1.3.19) to SET
locationNetIntfCfgMode variable (enterprises.3309.1.3.19.15) to 2 to enable
PPPoE Client.
To Next Page
Loading...
