HOTSPOT GATEWAY
System Administration 73
Defining Automatic Configuration Settings {Auto Configuration}
The HSG allows you to define parameters to enable the automatic configuration of
the system. See also, “RADIUS-driven Auto Configuration” on page 16.
1. From the Web Management Interface, click on Configuration, then Auto
Configuration.
The Autoconfiguration Settings screen appears:
2. Enable or disable Autoconfiguration, as required.
3. If you enabled Autoconfiguration, you must enter the following information into
the corresponding fields:
z RADIUS Authentication Name
z Radius Password
z Confirm Password
4. Click on the check box for Reboot after changes are saved? to reboot the
system when you submit your changes.
5. Click on the Submit button to save your changes, or click or the Reset button to
reset all data to its previous state.
To Next Page
Loading...
